p. 1

technical facts synoris 550/800n synoris opener synoris 550n 1/2hp for doors up to 550 lbs weight synoris 800n 3/4hp for doors up to 1200 lbs weight rails 7ft rail 8ft rail 10ft rail 12ft rail 14ft rail overall incl head 11 6 12 11 14 2 16 11 19 5 travel length 8 6 9 11 11 2 13 11 16 5 max short able 1 6 1 11 1 2 11 11 2 5 min overall incl head 10 11 13 15 17 connector wire allows to detach the head apart from the rail saves 10 in in overall length connect to terminal on circuit board red wire to terminal 7 green wire to terminal 8 5ft rail extension compatible with 7ft 8ft and 10ft rails max travel length is 14ft includes a second ceiling suspension bracket indicator lights on power head radio light lights or blinks during learning of a transmitter respective of the programming state power light lights up when the opener is supplied with power status light always blinks while the opener open/close the door blinks before two learning cycles safety light lights up when the photo eyes are interrupted command lights up when a command is given by wall station or transmitter photo eyes terminal on power head 5-6 non polarity photo eye with red sticker receiver should be out of the sunlight photo eye with green sticker transmitter flashing photo eyes led s no connection between photo eyes adjustment is necessary solid photo eyes led s powered make sure they are not connected to 3-4 no lighted photo eyes led s no connection to power head wall station -terminal on power head 3-4 non polarity green led normal operation red led vacation mode transmitter and wall station are locked 4 button transmitter programming to power head press learn button on power head once green solid led ­ press desired transmitter button programming to operate light press learn button on head twice green flashing led ­ press desired transmitter button delete all radio codes press learn button for 60 sec delete one radio code press and hold learn button until led is flashing 7sec press desired transmitter button

[close]

p. 2

troubleshooting synoris opener opener does not operate from either wall station or transmitter no power check if status led on power head is turned on insert 6 inch plastic bolt that locks the power head in place make sure the slide in part with connection terminal is in the back of the c-rail facing down disconnect power remove power head cover check terminal wires 7-brown 8-blue 9+10-red 11+12-black plug in the opener there may be a light switch that turns the outlet on make sure that it is turned on are all locks on the door disengaged has snow or ice built up under door door may be frozen to ground remove any restrictions the garage door spring may be broken engage motor carriage by pulling red rope on motor carriage opener does not close check if safety led on power head is turned on if yes photo eyes wires are in wrong terminal should be in 5 6 on power head wire is maybe damaged photo eyes are not properly aligned or leveled led on photo eyes have to be solid open motor carriage and check that all wires are connected and not loose opener does not operate from wall station are wiring connections correct check wall control wiring is wall station pushbutton lit if not disconnect wires from wall control and momentarily touch them together if opener runs replace wall control if openers does not run check wiring connections at the power head check wire for breaks under staples opener does not operate from transmitter -is the wall station led turned on turn off the vacation mode by holding down the lock button until the red led turns green does the transmitter indicator light up when the transmitter button is pressed if not replace battery -has the opener learned the code of the transmitter press learn button on power head once radio led solid and press desired transmitter button door reverses for no apparent reason is something obstructing the door pull emergency release handle and open door manually clear ice or snow from garage floor area where garage door closes press and hold the reset button on power head until status led stops blinking if door reverses from fully closed position readjust the front limit stop opener might not reach the limit switch power head lights do not stop blinking complete learning cycles open and close the door two times to finish the force learning process

[close]